But today, with solid-state drives (SSDs) as common as hard disks (HDs), both source and target can be either an HD or an SSD. The original name comes from a time when this meant spinning hard disks. drive cloningĭisk cloning, now often called drive cloning, means creating a true and faithful copy of one computer storage device on another - in other words, copying the contents of one storage device onto another storage device. It’s critical because its proper outcome is a machine that boots and runs when that operation is complete, the old drive removed, and the new drive put in its place. Such a cloning operation becomes critical on Windows PCs when the drive to be replaced is the boot/system drive, meaning it contains the files used to boot up the machine when it’s starting up or restarting, as well the operating system files used to run Windows itself. I'm currently attempting to use DISM to recover the drive with an install.wim file on a thumb stick, but it's quite the headache in a Windows PE environment.Cloning a PC drive comes in handy for a variety of reasons, but primarily when you want to replace one drive on a PC with another that is either bigger or faster than the original drive, if not both. sfc /scannow /offbootdir=C:\ /offwindir=C:\windows - same error.sfc /scannow - "Windows Resource Protection could not perform the requested operation".I've tried disabling auto recovery: bcdedit /set recoveryenabled No - but this just leads to another Recovery screen of: The operating system couldn't be loaded because the system registry file is missing or contains errors, File: \WINDOWS\System32\config\system, Error code: 0xc00000225.Using DISKPART to see that the drive is healthy, select it, assign it a letter, exit DISKPART, switch to the drive, bootrec /fixboot.The following is command prompt stuff I've tried within Recovery Mode off of a Win 10 install USB: There are no system restore points on the cloned drive to test.If I try System Recovery I get "Recovery" "Your PC/Device needs to be repaired" "A required device isn't connected or can't be accessed" "Error code: 0xc000000 e". Trying either Uninstall Updates option in Recovery Mode leads to failure.Trying any other option from Recovery Mode > Advanced Options > Startup Settings just ends up back at the "did not start correctly" message.Trying to boot to Safe Mode presents the same initial problem of "PC did not start correctly".Startup repair from recovery mode just leads to "Startup Repair couldn't repari your PC".I am trying to preserve the programs/data on this drive because a lot of it is expensive, licensed software and also because this is bugging me and there should be a way to fix it. When I turn it on it goes to a recovery screen Automatic Repair - "Your PC did not start correctly", if I reboot it will just loop to this message over and over. I do not see anything out of place in BIOS. I have checked the SSD in Disk Management on another device and the partition is active. The device is an HP Pavilion x360 with Windows 10. I have cloned a drive that is in QPT format from a HDD to SSD.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |